Outback F6-3.0L DOHC (2006)
Tightening torque: 44 Nm (4.5 kgf-m, 32.5 ft. lbs.)
16. Install the airbag module to steering wheel.
WARNING: Always refer to "Airbag System" before performing the service operation.
17. Connect the battery ground cable to battery.
CAUTION: After completion of installation, adjust the following two positions.
^
Positioning to the center of steering angle sensor
^
Positioning of the yaw rate and lateral G sensor to zero
The above procedure is required for VDCCM to identify the vehicle position afterward. For the setting procedure of step 2 above, refer to "VDC
Control Module and Hydraulic Control Unit".
