Outback F6-3.0L DOHC (2006)
Impact Sensor: Service and Repair
Curtain Airbag Sensor
Curtain Airbag Sensor
REMOVAL
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove the rear seat.
4. Detach the nuts and disconnect the airbag connector to remove the curtain airbag sensor.
INSTALLATION
CAUTION:
-
Do not reuse the bolt and nut.
-
Always use new bolts and nuts for them.
Install in the reverse order of removal.
Tightening torque: 7.4 N.m (0.75 kgf-m, 5.5 ft-lb)
