Outback F6-3.0L DOHC (2006)
2. Install the clutch pedal plate and clutch pedal so that the gap between them is 2 - 2.5 mm (0.08 - 0.10 inch), and then tighten the lock nut.
Tightening torque: 8 Nm (0.8 kgf-cm, 5.8 ft. lbs.)
3. Connect the clutch switch connector.
4. Confirm that the engine does not start when the clutch pedal is released.
5. Confirm that the engine starts when the clutch pedal is fully depressed.
INSPECTION
1. Confirm that the engine does not start when the clutch pedal is released. If the engine starts, adjust the clutch switch and inspect the starter
interlock circuit.
2. Confirm that the engine starts when the clutch pedal is fully depressed. If the engine does not start, adjust the clutch switch and inspect the starter
interlock circuit.
3. Check the clutch switch continuity. If continuity is not as specified, replace the switch.
1. Disconnect the clutch switch connector.
2. Measure the resistance between No. 1 and 2 of switch terminal.
Clutch switch (Starter interlock)
Clutch switch (Cruise control)
ADJUSTMENT
