Outback F6-3.0L DOHC (2006)
Power Steering Pump: Service and Repair
Oil Pump
REMOVAL
H4 MODEL
1. Disconnect the ground cable from battery.
2. Remove the air intake duct.
3. Remove the pulley belt cover.
4. Loosen the belt tension securing bolt and generator securing bolt, and then remove the power steering pump V-belt.
5. Disconnect the connector from power steering pump switch.
6. Disconnect the pressure hose and suction hose from oil pump.
CAUTION:
^
Do not allow fluid to come into contact with pulley belt.
^
To prevent foreign matter from entering the hose and pipe, cover the open ends with a clean cloth.
^
Non-turbo model
^
Turbo model