Outback F6-3.0L DOHC (2006)
2. Tighten the bolts which install power steering pump bracket.
3. Connect the pressure hose and suction hose each other.
Tightening torque: Eye bolt 39 Nm (4.0 kgf-cm, 28.9 ft. lbs.)
CAUTION: If a hose is twisted at this step, take care the hose may come into contact with some other parts.
4. Connect the connector to power steering oil pressure switch.
5. Install the tensioner adjuster.
6. Install the V-belts.
7. Install the cover of pulley belt.
8. Connect the battery ground cable to battery.
9. Pour the specified power steering fluid.
CAUTION: Never start the engine before feeding the fluid; otherwise vane pump might be seized up.
INSPECTION
BASIC INSPECTION
