Outback F6-3.0L DOHC (2006)
Axial play (Direction <- ->)
0.9 mm (0.035 inch) or less
2. Ditch deflection of pulley
Service limit: 1.0 mm (0.039 inch) or less
NOTE: Read the value for one surface of V ditch, and then the value for another off the dial.
3. Resistance to rotation of pulley
Service limit: Maximum load: 9.22 N (0.94 (kgs, 2.07 lbs.) or less
NOTE:
^
A rather higher value may be indicated when pulley starts turning.
^
Measure the load during rotation to make a judgment.
3. HYDRAULIC PRESSURE
NOTE:
^
Be sure to complete all items aforementioned in INSPECTION, prior to measuring hydraulic pressure. Otherwise, pressure cannot be measured
correctly.
^
Do not leave the valve of pressure gauge closed or hold the steering wheel at stop end for 5 seconds or more in any case, as the oil pump may be
damaged due to long keep of these conditions.
^
Put cloth at a place where fluid drops before pressure gauge is installed. Wipe off spilt fluid thoroughly after the measurement.
