Outback F6-3.0L DOHC (2006)
9. Tighten the nuts and bolts which hold the rear arm, front link, rear link, upper link and shock absorber.
NOTE: Always tighten the bushing in the state that wheels are in full contact with the ground and the vehicle is curb weight.
10. Install the sub frame support arm.
NOTE: Inspect the wheel alignment and adjust it if necessary.
Tightening torque: Refer to COMPONENT of General Description for tightening torque.
DISASSEMBLY
FRONT BUSHING
1. Set the ST A with the larger side of its inner diameter turned upward.
2. Set the rear arm with the protruding side of bushing turned upward.
3. Place the ST B on bushing, and push the bushing out.
ST A 20099AE020 INSTALLER & REMOVER SET
ST B 20099AE020 INSTALLER & REMOVER SET
2. REAR BUSHING
Using the STC and bearing puller, press the rear bushing out of place.
STC 20099AE040 INSTALLER & REMOVER SET
