Outback F6-3.0L DOHC (2006)
Tire Pressure Sensor: Service and Repair
Installation
Tire Pressure Monitoring System
INSTALLATION
TRANSMITTER (TIRE PRESSURE SENSOR)
1. Install the transmitter to the wheel by aligning it with valve hole. and then tighten with nuts.
Tightening torque: 7.5 Nm (0.76 kgf-cm, 5.53 ft. lbs.)
2. Install the tires to wheels.
CAUTION:
^
Use a tire changer when installing tire to wheel.
^
To prevent breaking of transmitter, set the tire changer boom in the position as shown in the figure.
3. Install the wheels to vehicle.
4. Register the transmitter ID to tire pressure monitoring control module.
TIRE PRESSURE MONITORING CONTROL MODULE
