Outback F6-3.0L DOHC (2006)
7. Shift the select lever to the "N" range, and then adjust the select cable position.
8. Install the heat shield cover.
9. Install the front, center and rear exhaust pipes, and the muffler. (SOHC and DOHC non-turbo model)
10. Install the center, rear exhaust pipes and the muffler.
INSPECTION
Check the removed cable and replace or adjust if damaged, rusty or malfunctioning.
1. Check the cable for smooth operation.
2. Check the inner cable for damage and rust.
3. Check the outer cable for damage, bends and cracks.
4. Check the boot for damage, cracks and deterioration.
5. Move the select lever from "P" to "D" range. Check the existence of feel to contact the detents in each range. If the detents cannot be felt or the
position pointer is improperly aligned, adjust the cable.
6. Check if the starter motor rotates when the select lever is set to "P" range.
7. Check the back-up light illumination when the select lever is in "R" range.
8. Check the parking lock operation when the select lever is in "P" range.
ADJUSTMENT
1. Shift the select lever to "N" range.
2. Remove the rear exhaust pipe and muffler.
3. Remove the heat shield cover.
4. Loosen the adjusting nuts on both sides.
5. With the select lever pushed towards the rear of the vehicle, turn the adjustment nut B until it just contacts the connector. Then loosen the nut for
1/2 turn.
