Outback F6-3.0L DOHC (2006)
8. Install the wheel and tighten the wheel nuts to specified torque.
Tightening torque: 110 Nm (11.2 kgf-m, 81.1 ft. lbs.)
DISASSEMBLY
Using the ST and a hydraulic press, push out the hub bolts.
ST 28399AGOOO HUB STAND
CAUTION:
^
Be careful not to hammer the hub bolts. This may deform the hub.
^
Do not reuse the hub bolt.
NOTE: Since the hub unit bearing can not be disassembled, only hub bolts can be removed.
ASSEMBLY
1. Attach the hub to the ST securely.
ST 927080000 HUB STAND
2. Using a press, Press the new hub bolts until their seating surfaces contact the hub.
NOTE: Use the 12 mm (0.47 inch) dia. holes in the HUB STAND to prevent bolts from tilting.
INSPECTION
Refer to "Front Axle" for inspection procedures.
CAUTION: If there is any fault in the bearing, replace hub unit bearing.
