Outback L.L.Bean Edition AWD F6-3.0L (2002)
Steering Angle Sensor: Service and Repair
REMOVAL
1. Disconnect battery around cable.
2. Remove airbag module.
WARNING: Always refer to "Airbag System" before performing airbag module service (if so equipped).
3. Remove steering wheel nut, then draw out steering wheel from shaft using steering puller.
NOTE: Steering wheel must be removed at the straight ahead position.
4. Remove the screw securing lower steering column cover.
5. Remove two screws securing upper steering column cover.
6. Release the lock of harness band and disconnect connector of steering angle sensor.