Outback L.L.Bean Edition AWD F6-3.0L (2002)
4. Insert piston into cylinder.
CAUTION: Do not force piston into cylinder.
5. Apply a coat of specified grease to boot and fit in groove on ends of cylinder and piston.
Grease: NIGLUBE RX-2 (Part No. 003606000)
To facilitate installation, fit boot starting with piston end.
6. Position boot in grooves on cylinder and piston.
7. Install boot ring. Be careful not scratch boot.
8. Apply a coat of specified grease to lock pin and guide pin, outer surface, cylinder inner surface, and boot grooves.
Grease: NIGLUBE RX-2 (Part No. 003606000)
9. Install lock pin boot and guide pin boot on support.
Rear
DISASSEMBLY
1. Remove the boot ring.
2. Remove the piston boot.
3. Gradually supply compressed air via inlet of caliper body to force piston out.
