Outback L.L.Bean Edition AWD F6-3.0L (2002)
1. When assembling, be sure to use recommended brake fluid.
2. Ensure that the inside wall of cylinder, pistons, and piston cups are free from dirt when assembling.
3. Be extremely careful not to damage, scratch, or dent cylinder inside wall, pistons, and piston cups.
4. Do not drop parts. Never attempt to use any part that has been dropped accidentally.
2. ASSEMBLING PROCEDURE
1. Assembling piston assembly:
Apply recommended brake fluid to inside wall of cylinder, and to outer surface of piston assembly, and install piston assemblies carefully into
cylinder.
2. Assembling cylinder pin:
3. Press the pawl and install the piston retainer into the master cylinder. (Without VDC)
4. Using pliers), install C-ring in its groove. (With VDC)
CAUTION: Make sure to install it firmly to groove.
5. Install seal to reservoir tank
6. Install pin with drift pins which secures reservoir tank to master cylinder.
