Outback L.L.Bean Edition AWD F6-3.0L (2002)
Wheel Speed Sensor: Service and Repair
Front
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect front ABS sensor connector located next to front strut mounting house in engine compartment.
3. Remove bolts which secure sensor harness to strut.
4. Remove bolts which secure sensor harness to body.
5. Remove bolts which secure front ABS sensor to housing, and remove front ABS sensor.
CAUTION:
^
Be careful not to damage pole piece located at tip of the sensor and teeth faces during removal.
^
Do not pull sensor harness during removal.
INSTALLATION
