Outback L.L.Bean Edition AWD F6-3.0L (2002)
10) Disconnect grommet (A) from toe board.
NOTE: From inside compartment, push grommet into hole.
11) Pull out the cable from the toe board hole.
12) Disconnect accelerator cable bushing from accelerator pedal lever.
13) Disconnect accelerator cable stopper (A) from bracket.
14) Separate accelerator cable and bracket.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
^
If cable clamp is damaged, replace it with a new one.
^
Never fail to cover outer cable end with boot.
^
Be careful not to kink accelerator cable.
^
Always use new clevis pins.
Accelerator cable lock nut tightening torque: 12 Nm (1.2 kgf-m, 9 ft. lbs.)
