Outback L.L.Bean Edition AWD F6-3.0L (2002)
Transmission Speed Sensor: Service and Repair
Front Vehicle Speed Sensor
13. Front Vehicle Speed Sensor
A: REMOVAL
1. Set up the vehicle on the lift.
2. Disconnect battery ground cable.
3. Remove air cleaner case or intake chamber.
4. Disconnect transmission connector.
5. Remove pitching stopper.
6. Remove the transmission connector from stay.
7. Lift-up the vehicle.
8. Clean transmission exterior.
9. Drain ATF completely.
NOTE: Tighten ATF drain plug after draining ATF.
Tightening torque: 25 Nm (2.5 kgf-cm, 18.1 ft. lbs.)
10. Remove front, center, rear exhaust pipes and muffler.
11. Remove the shield cover.
12. Remove the propeller shaft.
13. Place transmission jack under crossmember.
NOTE: Make sure that the support plates of transmission jack don't touch the crossmember.