Outback L.L.Bean Edition AWD F6-3.0L (2002)
5. Remove rear rail trim (E).
6. Remove cover (B) while detaching snap lock carefully. Put the outer belt center tongue (A) out to the other side of the trim through the hole.
7. Remove clips and hang down rear end of roof trim.
8. Disconnect harness and connector, and then remove outer belt center assembly.
INSTALLATION
Install in the reverse order of removal.
CAUTION: During installation, make sure that seat belts are not twisted.
After installation, make sure that seat belts can be smoothly extended and wound.
Outer Belt Side
OUTER BELT SIDE (WAGON BODY)
REMOVAL
1. Remove rear quarter trim.
2. Remove rear quarter upper trim.
