Outback L.L.Bean Edition AWD F6-3.0L (2002)
2 of 3
3 of 3
6. Remove bolts which hold rear sensor harness brackets.
7. Remove rear ABS sensor from rear arm.
8. When inspecting rear tone wheel, remove rear drive shaft as rear tone wheel is unitized with BJ assembly of rear drive shaft.
CAUTION:
^
Be careful not to damage pole piece located at tip of the sensor and teeth faces during removal.
^
Do not pull sensor harness during removal.
INSTALLATION
1. Install rear drive shaft to the vehicle.
2. Temporarily install rear ABS sensor on rear arm.