Outback L.L.Bean Edition AWD F6-3.0L (2002)
6. REAR WHEEL TOE-IN
^
Inspection
1. Using a toe-in gauge, measure rear wheel toe in.
Toe-in: 0 ±3 mm (0 ±0.12 inch)
2. Mark rear sides of left and right tires at height corresponding to center of spindles and measure distance "A" between marks.
3. Move vehicle forward so that marks line up with front sides at height corresponding to center of spindles.
4. Measure distance "B" between left and right marks. Toe-in can then be obtained by the following equation: A - B = Toe-in
^
Adjustment
1. Loosen self-locking nut on inner side of link rear.
CAUTION:
^
When loosening or tightening adjusting bolt, hold bolt head and turn self-locking nut.
^
Discard loosened self-locking nut and replace with a new one.
2. Turn adjusting bolt head until toe-in is at the specification.
