Outback L.L.Bean Edition AWD F6-3.0L (2002)
NOTE: Make sure that the vertical installing direction of coil spring is as shown in figure.
5. Set the coil spring correctly so that its end face (1) fits well into the spring seat as shown in the figure.
6. Install helper and dust cover to the piston rod.
7. Pull the piston rod fully upward, and install rubber seat and upper spring seat.
NOTE: Ensure that upper spring seat is positioned as shown in figure.
8. Install strut mount to the piston rod, and tighten the self-locking nut temporarily.
CAUTION: Be sure to use a new self-locking nut.
9. Using hexagon wrench to prevent strut rod from turning, tighten self-locking nut with ST.
ST 927760000 STRUT MOUNT SOCKET
Tightening torque: 54 Nm (5.5 kgf-m, 39.8 ft. lbs.)
10. Loosen the coil spring carefully.
E: INSPECTION
Check the disassembled parts for cracks, damage and wear, and replace with new parts if defective.
1. DAMPER STRUT
1. Check for oil leakage.
