Outback L.L.Bean Edition AWD F6-3.0L (2002)
Disconnect the wire connectors from each solenoid.
Note:
If the oil temperature sensor is integrated into the wire harness, disconnect the oil temperature sensor from the clip on the valve body.
Applicable transmission numbers for different types of oil temperature sensor as shown.
Note:
Try the following procedure if it is difficult to remove the transfer solenoid connector.
Caution:
-
Do not force wire connectors if removal is difficult.
-
Do not cut wiring.
a)
Hold the connector with tweezers.
b)
Tilt the connector and pull it out of the hole.
If the transfer solenoid connector still can not be removed from the case, it will be necessary to leave the harness attached during valve body removal.
This method should only be used as a last resort and otherwise, is not recommended.
Note:
