Outback L.L.Bean Edition AWD F6-3.0L (2002)
2. Connect harness connectors.
Connect connectors of same color, and secure connectors to valve body sing clips.
Tightening torque (Transmission ground terminal): 8 Nm (0.8 kgf-cm, 5.8 ft. lbs.)
3. Apply proper amount of liquid gasket to the entire oil pan mating surface.
Fluid packing: THREE BOND 1217B
4. Apply liquid gasket fully to 3 holes other than screw holes on the transmission case.
Fluid packing: THREE BOND 121 7B
5. Install the oil pan.
Tightening torque: 25 Nm (2.5 kgf-cm, 18.1 ft. lbs.)
6. Install the front and rear vehicle speed sensor, and also the torque converter turbine speed sensor, and then fasten the harness.
Tightening torque: 7 Nm (0. 7 kgf-cm, 5.1 ft. lbs.)
7. Install oil cooler outlet pipe.
NOTE: Be sure to use a new aluminum washer.
Tightening torque: 25 Nm (2.5 kgf-cm, 18.1 ft. lbs.)
