Outback L.L.Bean Edition AWD F6-3.0L (2002)
(1) Tighten bolts.
Tightening torque:
T1: 35 Nm (3.6 kgf-cm, 26 ft. lbs.)
T2: 75 Nm (7.6 kgf-cm, 55 ft. lbs.)
(2) Lower and remove transmission jack.
5. Install propeller shaft.
6. Install front center, rear exhaust pipe and muffler.
7. Lower and remove jack.
8. Connect transmission harness connector.
9. Install pitching stopper.
Tightening torque:
T1: 50 Nm (5.1 kgf-cm, 37 ft. lbs.)
T2: 58 Nm (5.9 kgf-cm, 43 ft. lbs.)
10. Install air cleaner case or air intake chamber.
11. Fill ATF up to the middle of the "COLD" side on level gauge by using the gauge hole.
12. Check the ATF level.
