Outback L.L.Bean Edition AWD F6-3.0L (2002)
12. Remove clip, and "P"-position switch with harness.
13. Remove detent spring
14. Remove spring.
CAUTION: Wear goggles. Do not allow spring to fly out during removal.
15. Remove bolt and then disconnect lever upper and lever lower.
ASSEMBLY
1. Clean all parts before assembly.
2. Apply grease [MULTEMP AC-D or equivalent] to each parts.
3. Assembly is in the reverse order of disassembly.
4. After completion of fitting, transfer select lever to position "P"-"1", then check whether the indicator and select lever agree, whether operating
force is.
