Outback L.L.Bean Edition AWD F6-3.0L (2002)
Clutch Switch: Testing and Inspection
INSPECTION
1. If clutch switch does not operate properly (or if it does not stop at the specified position), replace with a new one.
Specified position: L
2+1-5/ mm (0.079+0059/0 inch)
2. Check clutch switch continuity.
If continuity is not as specified, replace the switch.
(1) Disconnect the clutch switch connector.
(2) Measure the resistance between 1 and 2 of switch terminal.
Terminals/Specified resistance
When clutch pedal depressed:
1-2/Less than 1 Ohms
Terminals/Specified resistance
When clutch pedal not depressed:
1-2/More than 1M Ohms
^
Clutch switch (Starter interlock)
^
Clutch switch (With cruise control)
