Outback L.L.Bean Edition AWD F6-3.0L (2002)
10. Remove the two bolts, which hold center bearing to vehicle body.
11. Remove propeller shaft from transmission.
CAUTION: Be sure not to damage oil seals and the frictional surface of sleeve yoke.
NOTE:
^
Be sure to use an empty oil can to catch oil flowing out when removing propeller shaft.
^
Be sure to plug the opening in transmission after removal of propeller shaft.
12. Install the extension cap to transmission.
NOTE: If extension cap is not available, cover the opening with a vinyl bag in order to prevent transmission gear oil or ATF leakage.
INSTALLATION
1. Insert sleeve yoke into transmission and attach center bearing to vehicle body.
Tightening torque: 52 Nm (5.3 kgf-cm, 38.3 ft. lbs.)
