Outback L.L.Bean Edition AWD F6-3.0L (2002)
11. Install washer using ST1, ST2 and press.
CAUTION: Do not apply pressure in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
ST1 499277100 BUSHING 1-2 INSTALLER
ST2 499277200 INSTALLER
12. Install thrust bearing and needle bearing. Install driven shaft assembly.
13. Install drive pinion collar, needle bearing, adjusting washer No. 2, thrust bearing, adjusting washer No. 1 and differential bevel gear sleeve in that
order.
NOTE: Be careful to install spacer in proper direction.
