Outback [Legacy] AWD F4-2.5L DOHC (1996)
CHECK:
Connector & terminal
(P9) No.2 (+) - No. 1 (-)
Is voltage 0.7 ± 0.2 V when G sensor is inclined backwards to 90°?
YES: G sensor is normal.
NO: Replace G sensor.
Using Select Monitor
1) Turn ignition switch to OFF.
2) Connect select monitor connector to data link connector.
3) Turn select monitor into ABS mode.
4) Press [F], [1] and [0] on the select monitor.
5) Read the select monitor display.
CHECK:
Is the indicated reading 2.3 ± 0.2 V when the vehicle is in horizontal position?
YES: Go to next step 6).
NO: Replace G sensor.
6) Remove console box.
7) Remove G sensor from vehicle. (Do not disconnect connector.)
8) Read the select monitor display.
CHECK:
Is the indicated reading 3.9 ± 0.2 V when G sensor is inclined forwards to 90°?
YES: Go to next CHECK.
NO: Replace G sensor.