Outback [Legacy] AWD F4-2.5L DOHC (1996)
2) When terminal No.3 or No.6 are separated from diagnosis terminals (When select monitor is not used.)
3) When the brake pedal is released during sequence control and the braking lamp switch is set to off.
4) When brake pedal is depressed after ignition key is turned to ON, and before ABS warning light goes out.
(When select monitor is not used.)
5) When brake pedal is not depressed after ignition key is turned to ON, and within 0.5 seconds after ABS warning light goes out. (When select
monitor is not used.)
6) After completion of the sequence control.
7) When malfunction is detected. (When select monitor is used.)
Conditions For ABS Sequence Control
NOTE:
-
When select monitor is used, control operation starts at point A. The patterns from IGN key ON to the point A show that operation is started by
diagnosis connector.
-
HIGH means high voltage.
-
LOW means low voltage.
Installation
INSTALLATION
Hydraulic Unit
