Outback [Legacy] AWD F4-2.5L DOHC (1996)
(2) Apply engine oil to cap bearing surface and install cap on camshaft as shown by identification mark.
(3) Gradually tighten cap in at least two stages in the numerical order shown in figure, and then tighten to specified torque.
(4) Similarly, tighten cap on exhaust side. After tightening cap, ensure camshaft rotates only slightly while holding it at "base" circle.
3) Camshaft oil seal installation
Apply grease to new oil seal lips and press onto front end of camshaft by using ST1 and ST2.
CAUTION: Use a new oil seal.
ST1 499587100 OIL SEAL INSTALLER
ST2 499597000 OIL SEAL GUIDE
4) Rocker cover installation
(1) Install gasket on rocker cover.
Install peripheral gasket and ignition coil gasket.
(2) Apply fluid packing to four front open edges of peripheral gasket.
Fluid packing:
THREE BOND 1215 or equivalent
(3) Install rocker cover on cylinder head. Ensure gasket is properly positioned during installation.
5) Install ignition coil.
6) Install cam angle sensor.
7) Similarly, install parts on right-hand side.
2. RELATED PARTS
Install timing belt, camshaft sprockets and related parts.
