Outback [Legacy] AWD F4-2.5L DOHC (1996)
(3) Install oil pump on cylinder block. Be careful not to damage oil seal during installation.
CAUTION:
-
Do not forget to install 0-ring and seal when installing oil pump.
-
Align flat surface of oil pump's inner rotor with crankshaft before installation.
9) Install engine coolant pump and gasket.
CAUTION:
-
Be sure to use a new gasket.
-
When installing engine coolant pump, tighten bolts in two stages in numerical sequence as shown In Figure.
10) Install engine coolant pipe.
11) Install oil filter.
