Outback [Legacy] AWD F4-2.5L DOHC (1996)
(B13) No. 1 - Body/1O Volts or more.
(B13) No. 2 - Body/1O Volts or more.
[YES]:
Go to step 6.
[NO]:
Replace Ignitor.
6. Check harness connector of Ignitor ground circuit.
a. Turn Ignition Switch to "OFF".
b. Measure resistance between Ignitor and body.
[CHECK]:Connector & terminal:
(B13) No. 3 - Body/10 Ohms or less.
[YES]:
Go to step 7.
[NO]:
Repair harness between Ignitor connector and body.
7. Check harness connector between Engine Control Module (ECM) and Ignitor.
a. Disconnect connector from ECM.
b. Measure resistance of harness connector between ECM and Ignitor.
[CHECK]:Connector & terminal:
(B84) No. 13 - (B13) No. 1/10 Ohms or less.
(B84) No. 14 - (B13) No. 2/10 Ohms or less.
(B13) No. 69 - (B13) No. 3/10 Ohms or less.
[NO]:
Repair open circuit of harness between ECM and Ignitor connector.
[YES]
Go to next step.
c. Measure resistance of harness connector between ECM and body.
[CHECK]:Connector & terminal:
(B84) No. 13 - Body/1 M-Ohm or more.
(B84) No. 14 - Body/1 M-Ohm or more.
[NO]:
Repair short circuit of harness between ECM and Ignitor.
[YES]:
Confirm good connection in ECM
