Outback [Legacy] AWD F4-2.5L DOHC (1996)
Air Bag Harness: Testing and Inspection
Inspection and Replacement Standards
1. VEHICLES WHICH BECOME INVOLVED IN A COLLISION
If the vehicle equipped with an SRS airbag system is damaged in a collision, the airbag system parts must be checked and replaced in accordance
with the following standards:
After faulty parts are replaced, the warning light operation must be checked.
-
When the ignition switch is turned ON, it lights up for 8 seconds and then it goes out for at least 30 seconds.
-
The trouble code stored in memory must be erased after the check.
2. MAIN HARNESS
Inspection standard:
-
A vehicle damaged in a collision (regardless of whether or not airbag is deployed).
-
The designated trouble code is output during self-diagnosis. (Refer to "Diagnostics" Section.)
Replacement standard:
-
Harness circuit is broken, lead wire is exposed, corrugated tube is cracked, etc.
-
Connector is scratched or cracked.
-
The designated trouble code is output during self-diagnosis.