Outback [Legacy] AWD F4-2.5L DOHC (1996)
1. Install knock sensor to cylinder block.
Tightening torque:
23.5 ± 2.9 N.m (2.4 ± 0.3 kg-m, 17.3 ± 2.1 ft-lb)
NOTE: The extraction area of the knock sensor cord must be positioned at a 450 angle relative to the engine rear.
2. Connect knock sensor connector.
NOTE: The knock sensor cord must pass between the engine harness and engine coolant hose.
3. Fasten engine harness to engine coolant hose with band clip.
NOTE: Make sure that the throttle linkage does not interfere with other parts in the operating area.