Outback [Legacy] AWD F4-2.5L DOHC (1996)
1) Oil pump body
(1) Place oil pump in a vise, and remove two bolts which secure tank.
CAUTION: Do not place oil pump directly in vise; use soft pads and hold oil pump lightly to protect it.
(2) Remove four bolts which secure rear cover.
(3) Remove the following parts from front casing.
CAUTION: Discard old seal washer; replace with a new one.
2) Control valve
Slightly loosen outlet connector, and remove connector.
Remove the following parts for pump casing.
-
Spool valve assembly
-
Flow control spring
-
Connector
-
O-ring
