Outback [Legacy] AWD F4-2.5L DOHC (1996)
Specified grease:
SHELL 6459N
CAUTION:
-
If specified grease is not available, remove bearing grease and apply Auto Rex A instead.
-
Do not mix different types of grease.
11) Install disc cover to housing the three bolts.
Tightening torque:
14 ± 4 Nm (1.4 ± 0.4 kg-m, 10.1 ± 2.9 ft-lb)
12) Attach hub 10 ST1 securely.
13) Clean dust or foreign particles from the polished surface of hub.
14) Using ST2, press bearing into hub by driving inner race.
ST1 927080000 HUB STAND
ST2 927120000 HUB INSTALLER
Installation
E: INSTALLATION
1) Install transverse link ball joint to housing.
Tightening torque:
44 ± 6 Nm (4.5 ± 0.6 kg-m, 32.5 ± 4.3 ft-lb)
2) While aligning alignment mark on camber adjusting bolt head, connect housing and strut.
CAUTION: Use a new self-locking nut.
Tightening torque:
147 ± 15 Nm (15 ± 1.5 kg-m, 108 ± 11 ft-lb)
3) Install speed sensor and harness on housing (only vehicle equipped with A.B.S.).
4) Install disc rotor on hub.
5) Install disc brake caliper on housing.
Tightening torque:
59 ± 10 Nm (6 ± 1 kg-m, 43 ± 7 ft-lb)
6) Install front drive shaft.
7) Connect stabilizer link.
