Outback [Legacy] AWD F4-2.5L DOHC (1996)
3) Clean housing interior completely. Using ST1 and ST2, press bearing into housing.
ST1 927430000 HOUSING STAND
ST2 927440000 BEARING REMOVER
CAUTION:
-
Always press outer race when installing bearing.
-
Be careful not to remove plastic lock from inner race when installing bearing.
-
Charge bearing with new grease when outer race is not removed.
4) Install snap ring.
CAUTION: Ensure snap ring fits in groove properly.
5) Using ST1 and ST2, press outer oil seal until it comes in contact with snap ring.
ST1 927430000 HOUSING STAND
ST2 927460000 OIL SEAL INSTALLER
6) Invert both ST1 and housing.
7) Using ST2, press inner oil seal into housing until it touches bottom.
