Outback Limited Wagon AWD F4-2.5L SOHC (2002)
2. Loosen throttle position sensor holding screws.
NOTE: For detailed operation procedures, refer to the Subaru Select Monitor Operation Manual.
3. Insert the cartridge to Subaru Select Monitor. <Ref. to PREPARATION TOOL, General Description.>
4. Connect Subaru Select Monitor to the data link connector (A).
5. Turn ignition switch to ON, and Subaru Select Monitor switch to ON.
6. Select {2. Each System Check} in Main Menu.
7. Select {Engine Control System} in Selection Menu.
8. Select {1. Current Data Display & Save} in Engine Control System Diagnosis.
9. Select {1.12 Data Display} in Data Display Menu.
10. Adjust throttle position sensor to the proper position to match with the following specifications.
Condition: Throttle fully closed
Throttle opening angle 0.00 %
Throttle sensor voltage 0.50 V
11. Tighten throttle position sensor holding screws.
Tightening torque: 1.6 Nm (0.16 kgf-m, 1.2 ft-lb)
