Outback Sport F4-2.5L (2010)
ensure wiring is secure in all clips and is clear of any metal edges.
e) Install paddle shifters to the new steering wheel using new screws.
Tightening Torque: 1.7 N~m (0.2 kgf-m, 1.3 ft-lb)
f) Verify correct routing of the satellite switch wiring harness to prevent interference with the dynamic damper (DD) to be installed in the next
step.
g) Install the Dynamic Damper (DD) to the new steering wheel. Do not allow the wiring harness to interfere with the DD. Make sure there is a
minimum of 5mm clearance between satellite switch harness and the dynamic weight of the DD on all sides.
Tightening Torque: 1.7 N~m (0.2 kgf-m, 1.3 ft-lb)
CAUTION:
It is crucial that the wiring harness does not interfere with the DD.
h) Install the new steering wheel.
Tightening Torque: 39 N~m (4.0 kgf-m, 28.8 ft-lb)
i)
Connect electrical connections to the roll connector and secure the harnesses together with electrical tape, as seen below.
