Outback Sport F4-2.5L (2010)
b) Insert the engine mount insert into the gap above the front engine mount horizontal bolt. The two opposing tabs on the insert will point toward the
front and rear of the car, not up and down.
c) Lower the engine down into the normal at rest position.
d) Install the front exhaust pipe.
2) Tighten the front sub-frame bolts to the specified torque.
Tightening Torque: 50 N~m (5.0 kgf-m, 36.8 ft-lb)
3) Replace both LH and RH front arm assemblies.
a) Remove the front stabilizer link and ball joint from the front arm.
