Outback Sport F4-2.5L SOHC (2005)
Brake Caliper: Service and Repair
Rear
Rear Disc Brake Assembly
REMOVAL
14 INCH TYPE
CAUTION: Do not allow brake fluid to come in contact with vehicle body; wash away with water and wipe off completely if spilled.
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift-up the vehicle, and then remove the wheels.
4) Disconnect the brake hose from caliper body assembly.
5) Remove the bolt securing lock pin to caliper body.
6) Raise the caliper body and move it toward vehicle center to separate it from support.
7) Remove the support from housing.
NOTE: Remove the support only when replacing it or the rotor. It need not be removed when servicing the caliper body assembly.
8) Clean mud and foreign particles from the caliper body assembly and support.
CAUTION: Be careful not to allow foreign particles to enter brake hose connector.
17 INCH TYPE
CAUTION: Do not allow brake fluid to come in contact with vehicle body; wash away with water and wipe off completely if spilled.
1) Set the vehicle on a lift.
2) Loosen the wheel nuts.
3) Lift-up the vehicle, and then remove the wheels.
4) Remove the brake pads from caliper body.
5) Disconnect the brake hose from caliper body.
6) Remove the caliper body from housing.
7) Clean mud and foreign particles from the caliper body.
CAUTION: Be careful not to allow foreign particles to enter brake hose connector.
INSTALLATION
14 INCH TYPE
1) Install the support on housing.
