Outback Sport F4-2.5L SOHC (2005)
Tightening torque: 53 Nm (5.4 kgf-m, 39.1 ft. lbs.)
2) Apply thin coat of Molykote AS880N (Part No. K0777YA010) to the frictional portion between pad and pad clip.
3) Install the pads on support.
4) Install the caliper body on support.
Tightening torque: 37 Nm (3.8 kgf-m, 27.5 ft. lbs.)
5) Replace the brake hose gaskets with new ones, and then connect the brake hose.
Tightening torque: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
6) Bleed air from the brake system.
17 INCH TYPE
1) Install the caliper body on housing.
Tightening torque: 65 Nm (6.6 kgf-m, 47.9 ft. lbs.)
2) Install the pads on caliper body.
3) Replace the brake hose gaskets with new ones, and then connect the brake hose.
Tightening torque: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
4) Bleed air from the brake system.
DISASSEMBLY
14 INCH TYPE
1) Remove the boot ring.
2) Remove the piston boot.
3) Place a wooden block in caliper body as shown in the figure to prevent the piston from jumping out and avoid being damaged.
4) Gradually supply compressed air via the installation hole of brake hose to force the piston out.