Outback Sport F4-2.5L SOHC (2005)
5) Insert the piston into cylinder.
CAUTION: Do not force the piston into cylinder.
6) Position the boot in grooves on cylinder and piston.
7) Apply a coat of specified grease to the lock pin and guide pin outer surface, cylinder inner surface, and boot grooves.
Grease: NIGLUBE RX-2 (Part No. K0779GA 102)
8) Install the lock and guide pin boot on support.
17 INCH TYPE
1) Clean the caliper body interior using brake fluid.
2) Apply a coat of brake fluid to the piston seal, and then install the piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4) Apply a coat of specified grease to the boot and install it in the groove on piston.
Grease: NIGLUBE RX-2 (Part No. K0779GA 102)