Outback Sport F4-2.5L SOHC (2005)
15) Read values indicated on the pressure gauges and check if they meet the standard value.
16) After checking, remove the pressure gauges from caliper bodies.
17) Connect the air bleeder screws to RL and RR caliper bodies.
18) Bleed air from the brake system.
CHECKING THE HYDRAULIC UNIT ABS OPERATION WITH BRAKE TESTER
1) In the case of non-turbo AT model, install a spare fuse with the FWD connector in the main fuse box to simulate FWD model.
NOTE: The AWD circuit of MT and turbo AT model can not be disabled.
2) Prepare for operating the ABS sequence control.
3) Set the front wheels or rear wheels on the brake tester and set the select lever's position at "N" range.
4) Operate the brake tester.
5) Perform the ABS sequence control.
6) Hydraulic unit begins to work; and check the following working sequence.
(1) The FL side performs decompression, holding and compression in sequence, and subsequently the FR side repeats the cycle.
(2) The RR side performs decompression, holding and compression in sequence, and subsequently the AL side repeats the cycle.
