Outback Sport F4-2.5L SOHC (2005)
Alarm Module: Testing and Inspection
Security Control Unit
INSPECTION
IMPACT SENSITIVITY TEST
1. Remove the key from the ignition switch.
2. Close all windows.
3. Close all doors and the rear gate.
4. Cover the hood with a blanket.
5. Press the LOCK/ARM button of the keyless transmitter.
6. Confirm that the security indicator light blinks every 2 seconds.
7. Hit the center of the windshield with your palm and make sure the alarm operates.
If NG, adjust the impact sensitivity.
PROCEDURE
1. PASSIVE ARMING (ENTER THE PASSIVE MODE)
NOTE: When passive arming mode has been programmed, arming of the system is automatically accomplished without using the remote
transmitter. Note that in this mode, DOORS MUST BE LOCKED.
To enter the passive mode
1. Open the driver's door.
2. Remove the two clips fastening the front portion of the side sill cover with a screwdriver.
3. Remove the side sill cover by pulling it up.