subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Airbag Systems|Page 4923 > < System Relay, HVAC|Locations|Page 4917
Page 1
background image

Repairs and Inspections Required After a Collision: Service and Repair
Airbag Systems

Inspection Locations After a Collision

REPLACEMENT

When airbag system is deployed, replace the following parts.

1. FRONT COLLISION

1. Driver's airbag module
2. Passenger's airbag module
3. Driver's seat belt (pretensioner)
4. Passenger's seat belt (pretensioner)
5. Airbag control module
6. Front sub-sensor
7. Roll connector

2. SIDE COLLISION

1. Airbag control module
2. Side airbag module (operating side seat backrest)
3. Side airbag sensor (operating side)

3. INSPECTION OF OTHER PARTS

Check for the following parts, replace the damaged parts with new ones.
1. Steering wheel and steering shaft

Check the steering wheel and steering shaft for mounting condition and deflection of axial and radical, upward and downward direction. Check
the steering shaft for deflection of axial and radical direction with tilt lever released. (After a collision, absorbing part of steering shaft may
inflate.)

2. Check the direct type connector of driver's airbag module, pretensioner, etc. for damage, and also check each harness for pinch and connector

damage. If damage is found, replace the harness as a unit.

INSPECTION

If the vehicle is involved in a collision, even if it is a slight collision, be sure to check the following system parts.

1. DRIVER'S AIRBAG MODULE

1. Check for the following, and replace damaged parts with new parts.

-

Airbag module is cracked or deformed.

-

Harness and/or connector is cracked, deformed or open. Lead wire is exposed.

-

The module surface is fouled with grease, oil, water or cleaning solvent.

2. When installing a new driver's airbag module, check the following, and replace the damaged parts with new ones.

-

The steering wheel is in the way, making it difficult to install the airbag module.

-

The clearance between the driver's airbag module and steering wheel is not constant.

-

The steering wheel deformation in axial and radial directions exceed limits.

Specifications:
Height deflection A: Less than 6 mm (0.24 in)
O.D. deflection L: Less than 17 mm (0.67 in)

2. PASSENGER'S AIRBAG MODULE

Check for the following, and replace damaged parts with new parts.

Airbag Systems|Page 4923 > < System Relay, HVAC|Locations|Page 4917