Outback Sport F4-2.5L SOHC (2005)
8) Install the torque converter clutch case assembly to the transmission case assembly.
9) Install reduction driven gear.
10) Install reduction drive gear. (MPT model)
11) Install the center differential carrier. (VTD model)
12) Combine the extension case with the transmission case, and install vehicle speed sensor 1 (rear).
13) Insert inhibitor switch and transmission connector into stay.
14) Install air breather hose.
15) Install the oil cooler pipes.
16) Install the oil charger pipe with O-ring.
17) Insert the input shaft while turning lightly by hand. At this time, not to damage the bushing.
Normal protrusion A: 50 - 55 mm (1.97 - 2.17inch)
18) Install the torque converter clutch assembly.
19) Install the transmission assembly to the vehicle.
DISASSEMBLY
