Outback Sport F4-2.5L SOHC (2005)
8. Tighten the boot bands using the ST, torque wrench and socket flex handle.
ST 28099AC000 BOOT BAND PLIER
Tightening torque:
Large boot band 157 Nm (16.0 kgf-m, 116 ft. lbs.) or more
Small boot band 133 Nm (13.6 kgf-m, 98 ft. lbs.) or more
9. Place the PTJ boot at the center of shaft.
10. Align the alignment marks, and then install the trunnion on shaft.
11. Install the snap ring to shaft.
CAUTION: Confirm that the snap ring is completely fitted in shaft groove.
12. Fill 100 to 110 g (3.53 to 3.88 oz) of specified grease into the interior of PTJ outer race.
13. Apply a coat of specified grease to free ring and trunnion.
14. Align the alignment marks on free ring and trunnion, and then install the free ring.
CAUTION: Be careful with the free ring position.