Outback Sport F4-2.5L SOHC (2005)
10. Align the outer race track and ball positions and place in the part where shaft, inner race, cage and balls are previously installed, and then fit the
outer race.
11. Install the circlip in the groove on DOJ outer race.
NOTE:
^
Assure the balls, cage and inner race are completely fitted in the outer race of DOJ.
^
Exercise care not to place the matched position of circlip in ball groove of outer race.
^
Pull the shaft lightly and assure that the circlip is completely fitted in groove.
12. Apply an even coat of the specified grease [20 to 30 g (0.71 to 1.06 oz)] to the entire inner surface of boot. Also apply grease to shaft.
13. Install the DOJ boot taking care not to twist it.
NOTE:
^
Inside of the larger end of DOJ boot and boot groove shall be cleaned so as to be free from grease and other substances.
^
When installing the DOJ boot, position the outer race of DOJ at center of its travel.
14. Put a new band through the clip and wind twice in alignment with band groove of boot.
NOTE: When tightening the boot, exercise care so that air within boot is appropriate.
15. Tighten the band using the ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE: Tighten the band until it cannot be moved by hand.
16. Tap on the clip with the punch provided at the end of ST.
ST 925091000 BAND TIGHTENING TOOL
