Outback Sport F4-2.5L SOHC (2005)
Liftgate Window Glass: Service and Repair
Rear Gate Glass
REMOVAL
1. Remove the rear wiper motor.
2. Disconnect the electrical connector from rear defogger terminal.
3. Remove the glass in the same procedure as for windshield glass.
INSTALLATION
1. Apply adhesive in the same procedure as for windshield glass.
2. Insert the glass locating pin into the rear gate hole, and after pushing on the area around the locating pin to secure it, push lightly all around the
area to seal it.
3. About one hour after installation, conduct a water leak test.
4. After completion of all work, allow the vehicle to stand for about 24 hours.
NOTE:
-
When the door is opened/closed after glass is bonded, always lower the door glass and then open/close it carefully.
-
Move the vehicle slowly.
-
For minimum drying time and time the vehicle must be left standing before driving after bonding, follow the instructions or instruction manual
from adhesive manufacturer.
-
When a vehicle is returned to the user, tell him or her that the vehicle should not be subjected to heavy impact for at least three days.
5. Connect the rear defogger terminals.
6. Install the rear wiper.
